A wide range of fast fit energy saving controls that are easily retrofitted into any building.
The controls are designed to offer a low installation cost, quick payback solution to energy saving.The widest range of controls on the market from a simple time-lag switch to a full lighting control system.
Vitesse PIR Detector : General Purpose PIR detectors : No-neutral PIR Detector : Microwave Detectors
Environmental
Water Management : Emergency Lighting Test : Hand Driers : Fly Killers : Ventilation Controls
Time Control
No-neutral Time Lag Switches : Multi-range
Timers
: Runback Timer
Heating/Air Conditioning Control
Lighting Control Systems
Enerbus Lighting Control :
Enerbus RAPID Lighting Control
: Vitesse Marshalling Box .
Energy Controller
The Energy Controller saves up to 30% of power
used by fluorescent lights, with minimal impact on light levels. Now you can
dramatically reduce energy consumption and your power bills all without lifting
a finger! Plus, the Energy Controller can pay for itself in approximately
1-2 years, based on average kWh energy costs.
How does it work?
The unit operates in one of two modes, Normal or Economy. In Normal mode the standard supply voltage (240Vac) is applied to the load. After a short time to allow lamps to strike and warm up, the Energy Controller enters Economy mode and the voltage applied to the lamps is reduced. When running in Economy mode, the voltage is decreased by approximately 15% of the supply and energy consumption by fluorescent lighting.
The Energy Controller uses a patented, soft-switching auto-transformer to switch from normal voltage once the lights have been turned on. Lighting then operates at a reduced voltage, still within the range of the power utility, with only a small reduction in light output.
The Energy Controller is entirely failsafe. In the event of a failure it returns to standard mains power. The controller continuously monitors the mains voltage and avoids “Brownouts” by switching out of Economy mode when the voltage drops by 12.5%. 30% energy savings comprise 15% reduction in step voltage and 15% power factor improvement.